This box contains approximately 3500 flat backs, in the following sizes: 2.0 mm / 2.5 mm / 3 mm / 4 mm / 5 mm / 6 mm.
How do you use these flat backs?
Step 1 : Finish your design or manicure as normal. Apply a thin layer of top coat over the entire nail and cure.
Step 2 : Apply a layer of Gel UV Glue to the area where you want to apply the studs. This can be done, for example, with a liner brush or a dotting tool. Do not harden it yet.
Tip! Do not apply the gel too thinly. If you use the right amount, the pearls will be well encapsulated when applied to the uncured Gel UV Glue.
Step 3 : Use a Wax Tool Picker to pick up the stud, and place it into the layer of Gel UV Glue. Cure this layer completely in the lamp (LED 90 sec; UV 180 sec).
Step 4 : The most important thing is that the studs on the sides are encapsulated to make your design 'impact proof'. If they are not yet sufficiently encapsulated after application in step 3: use a liner brush and apply a layer of Gel UV Glue around the pearls. Cure completely in the lamp (LED 90 sec; UV 180 sec). In principle, it is not necessary to seal the Gel UV Glue with a top coat. To keep the studs beautiful for as long as possible, we recommend sealing them last with a thin layer of top coat.